Two different problems then. First to get 5250 to use port 992 (SSL) then
you must configure the system (or other) certificate to support the telnet
server.
See:
https://www.ibm.com/support/pages/configuring-ssl-telnet-and-host-servers-se
rver-authentication-first-time
Second problem is you must configure LAN console. That was in the links I
sent before. It's not hard, but you must do the steps as IBM has laid them
out, else not connection......
--
Jim Oberholtzer
Agile Technology Architects
-----Original Message-----
From: MIDRANGE-L <midrange-l-bounces@xxxxxxxxxxxxxxxxxx> On Behalf Of James
H. H. Lampert via MIDRANGE-L
Sent: Wednesday, August 11, 2021 11:14 AM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxxxxxxxx>
Cc: James H. H. Lampert <jamesl@xxxxxxxxxxxxxxxxx>
Subject: Re: Getting LAN Console up, was Re: Is there such a thing as a
Twinax controller for an E4A?
On 8/11/21 6:51 AM, midrangel@xxxxxxxxxxxxxxxxx wrote:
Look in the AcsConfig.properties file.
This just gets weirder.
It took me quite a while to find an "AcsConfig.properties" other than the
"blank template" one in my downloads directory.
Finally, doing a "find" from a command line turned one up in
/usr/local/ibmiaccess, which did indeed have a component exclusion at the
end.
Commenting this out brought up the full sidebar. But while "5250 Emulator"
does indeed work (but *not* if I select "Use SSL in the connectino panel),
"5250 Console" gives the same error as Virtual Control Panel.
--
JHHL
midrange.com
