Not the partition number. There are a couple of other things as well but
that's one you have to shut down for.
--
Jim Oberholtzer
Agile Technology Architects
-----Original Message-----
From: MIDRANGE-L <midrange-l-bounces@xxxxxxxxxxxx> On Behalf Of Rob Berendt
Sent: Friday, December 14, 2018 9:46 AM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Subject: RE: HMC 7063-CR1 configuration and initial P9 power on
Shouldn't you be able to do maintenance on a profile whether it is activated
or not? The partition just only takes the changes to the profile when it's
activated, from profile.
If so, then, based on what I'm seeing, you cannot change the partition id.
So creating your partitions in order, and perhaps even a dummy partition in
between just so you get the same partition id's as on your old system, is
one way to get the desired partition numbers.
Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600 Mail
to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com
From: "Jim Oberholtzer" <midrangel@xxxxxxxxxxxxxxxxx>
To: "'Midrange Systems Technical Discussion'"
<midrange-l@xxxxxxxxxxxx>
Date: 12/14/2018 09:56 AM
Subject: RE: HMC 7063-CR1 configuration and initial P9 power on
Sent by: "MIDRANGE-L" <midrange-l-bounces@xxxxxxxxxxxx>
I don't have a partition to try it on but I believe the partition must be
deactivated, then go into profile maintenance and you should be able to
change it. Then re-activate.
--
Jim Oberholtzer
Agile Technology Architects
midrange.com
