× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Hi Paul

yes, that's assuming the IP address is already assigned (like for instance
if you moved it from another HMC) The find function uses a range of
addresses to look for a specific system, again assuming an address has been
assigned. Basically there's a DHCP thing going on between the HMC and the
Managed Server.

if the system has not been powered on or connected to a HMC before then
just check your HMC cabling to make sure it is correct. If you have to
change it you might need to give it a few minutes.I;ve occasionally been a
bit frustrated and then the managed system just pops up so going for a
short walk can't hurt. A watched pot never boils and all that.

On Tue, Dec 11, 2018 at 11:57 AM Steinmetz, Paul <PSteinmetz@xxxxxxxxxx>
wrote:

Evan,

I have all that.
The "add managed system" is asking for an IP address.
???

Paul


-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
Evan Harris
Sent: Monday, December 10, 2018 5:53 PM
To: Midrange Systems Technical Discussion
Subject: Re: HMC 7063-CR1 configuration and initial P9 power on

Hi Paul

You should only need the connection between the HMC and the server at this
point, so you only need the connection to between Ethernet Connector 1 on
the HMC and HMC1 port on the Power server.

If the cabling is correct you can always use the HMC Find Managing system
function to go and search for the system. if it is not connected then
connecting it should be enough but you will need to be a little bit patient
as it takes a few minutes.


On Tue, Dec 11, 2018 at 11:45 AM Steinmetz, Paul <PSteinmetz@xxxxxxxxxx>
wrote:

Evan,

I'll have to repeat these steps below, since my HMC did not see the
server.

- Connect Power to the Managed System; watch them complete the intitial
power on sequence (basically until the power light is flashing)
- Look for the managed system in the HMC using the serial number to
verify; if my cabling is correct it should have connected and be waiting
for first time authentication

Question.
Do the server's 5899 NIC cards have to be connected at this time?
I didn't think they did?

Paul

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
Evan Harris
Sent: Monday, December 10, 2018 5:39 PM
To: Midrange Systems Technical Discussion
Subject: Re: HMC 7063-CR1 configuration and initial P9 power on

Hi Paul

I am not sure which manual the table you are referring to appears in, but
generally the sequence of events I follow is something like:
- cable up the machine(s) and HMC including network cables
- Power up the HMC and perform basic configuration
- Connect Power to the Managed System; watch them complete the
intitial power on sequence (basically until the power light is flashing)
- Look for the managed system in the HMC using the serial number to
verify;
if my cabling is correct it should have connected and be waiting for
first
time authentication
- Go through and enter the managed system passwords and ASMI passwords
- At that point I might start the Managed system using the HMC

I would not skip the passwords as they are required to allow the HMC to
manage the system.

Hope this helps.

On Tue, Dec 11, 2018 at 10:29 AM Steinmetz, Paul <PSteinmetz@xxxxxxxxxx>
wrote:

I'm following Table 1. Manual HMC configuration tasks and where to find
related information



13. Connect the managed system to a power source.

14. Set passwords for the managed system, and each of the ASMI
passwords
(general and admin) Setting passwords for the managed system

15. Access ASMI to set the date and time on the managed system.

16. Start the managed system and return to this checklist when you have
completed this step.



Questions.

1) Do steps 14 and 15 need to be completed at this time or can they be
done at a latter point?

I've never logged into our ASMI on our current system.



Step 16,

2) How is the managed system stated at this point?

Does it need to be powered on manually before it is added "Add managed
system"?

How is it powered on this done if not yet appearing on the HMC?


Thank You
_____
Paul Steinmetz
IBM i Systems Administrator

Pencor Services, Inc.
462 Delaware Ave
Palmerton Pa 18071

610-826-9117 work
610-826-9188 fax
610-349-0913 cell
610-377-6012 home

psteinmetz@xxxxxxxxxx<mailto:psteinmetz@xxxxxxxxxx>
http://www.pencor.com/



--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: https://amazon.midrange.com



--

Regards
Evan Harris
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: https://amazon.midrange.com
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: https://amazon.midrange.com



--

Regards
Evan Harris
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: https://amazon.midrange.com
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: https://amazon.midrange.com




As an Amazon Associate we earn from qualifying purchases.

This thread ...

Follow-Ups:
Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.