×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Will the traffic from one FTP go across both ports?
Or do I need to run multiple FTPs?
Paul
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bryan Dietz
Sent: Friday, October 26, 2018 9:54 AM
To: Midrange Systems Technical Discussion
Subject: Re: How to configure a 2nd Enthernet port to a 2nd Eternet Switch for Load balancing/fail over
failure is easy, just unplug one of the cables, if different switches,
unplug the power
FTP is one way to test. maybe ftp some PTF images from different PC's
to the IFS.
do inbound and outbound tests.
I would think there are some traffic creation programs out there
https://www.google.com/search?q=create+network+traffic
Bryan
Steinmetz, Paul wrote on 10/26/2018 9:21 AM:
Interface for that IP / Line was created, but I forgot to start it.
Normally autostarts from an IPL.
ETHAGG ACTIVE
ETHAGNET ACTIVE
ETHAGTCP ACTIVE QTCPWRK QSYS 793431
1) Now I need to create some processes that will send a large amount of traffic.
2) How can I test the load balance and the failure
Paul
This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
