RE: Console recovery / take over is currently turned off.

If the console works, but the control panel won't display, it is because you need to go into DST and go into devices, and then grant the LAN Console device that you are using (QCONSOLE, QCONSOLE00, etc) remote control panel. Default is revoked.

Pete

--
Pete Massiello
iTech Solutions
http://www.itechsol.com
http://www.iInTheCloud.com




-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Pete Helgren
Sent: Tuesday, January 15, 2013 1:12 PM
To: Midrange Systems Technical Discussion
Subject: Re: Console recovery / take over is currently turned off.

Wishing I had a 5250 terminal connected with twinax.....

IVM isn't responding (long story and one that I have lived through
before) It *might* have had a control panel but I can't remember (and can't see it). I am a little baffled as to why the control panel won't display in Ops Navigator but what the hey...this is a development box and I'll bounce it from the AMM. Then I hope the Ethernet line will vary back on when it comes back up and THEN I'll connect with Ops Nav. I should be able to vary off the Ethernet line then correct? Ops nav doesn't need a configured Ethernet line because it uses a different NIC ... right?

Pete Helgren
www.petesworkshop.com
GIAC Secure Software Programmer-Java

On 1/15/2013 8:32 AM, DrFranken wrote:

Pete,

Can you go into IVM and use Operator Panel Functions there to do the
65, 21, 21? I know you can do this with HMC but I think that's also
available on IVM.

- Larry "DrFranken" Bolhuis

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a moment to review the archives at http://archive.midrange.com/midrange-l.