Re: Console recovery / take over is currently turned off.

[Vernon Hamberg <vhamberg@xxxxxxxxxxxxxxx>]

Hi Pete

I just looked up this topic - there are V5R4 instructions at this URL

http://tinyurl.com/c42cq7k

There is something about needing a unique SST user, esp. if using LAN 
console.

HTH
Vern

On 1/15/2013 12:12 PM, Pete Helgren wrote:
> Wishing I had a 5250 terminal connected with twinax.....
>
> IVM isn't responding (long story and one that I have lived through
> before) It *might* have had a control panel but I can't remember (and
> can't see it).  I am a little baffled as to why the control panel won't
> display in Ops Navigator but what the hey...this is a development box
> and I'll bounce it from the AMM. Then I hope the Ethernet line will vary
> back on when it comes back up and THEN I'll connect with Ops Nav.  I
> should be able to vary off the Ethernet line then correct?  Ops nav
> doesn't need a configured Ethernet line because it uses a different NIC
> ... right?
>
> Pete Helgren
> www.petesworkshop.com
> GIAC Secure Software Programmer-Java
>
> On 1/15/2013 8:32 AM, DrFranken wrote:
> > Pete,
> >
> > 	Can you go into IVM and use Operator Panel Functions there to do the
> > 65, 21, 21?  I know you can do this with HMC but I think that's also
> > available on IVM.
> >
> >            - Larry "DrFranken" Bolhuis