×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Wishing I had a 5250 terminal connected with twinax.....
IVM isn't responding (long story and one that I have lived through
before) It *might* have had a control panel but I can't remember (and
can't see it). I am a little baffled as to why the control panel won't
display in Ops Navigator but what the hey...this is a development box
and I'll bounce it from the AMM. Then I hope the Ethernet line will vary
back on when it comes back up and THEN I'll connect with Ops Nav. I
should be able to vary off the Ethernet line then correct? Ops nav
doesn't need a configured Ethernet line because it uses a different NIC
... right?
Pete Helgren
www.petesworkshop.com
GIAC Secure Software Programmer-Java
On 1/15/2013 8:32 AM, DrFranken wrote:
Pete,
Can you go into IVM and use Operator Panel Functions there to do the
65, 21, 21? I know you can do this with HMC but I think that's also
available on IVM.
- Larry "DrFranken" Bolhuis
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
