SAVRSTLIB problem

I checked the archives, and there was no answer to help me, so here goes...


I have a 520 and a 515. I have configured AnyNet and can STRPASTHR ­ both
ways. I am attempting SAVRSTLIB from the 520 ­ pushing to the 515. I have
checked my Communication Entries, and tested with the user as *NONE, as
QUSER (which I think was installed when ObjectConnect was installed), and
also as *SYS.

Yet, I still get this error on the 520:
~~~~~~~~~~~~~~~~~~~~
Message . . . . : Communications failure. Session was not started.
Cause . . . . . : The system has detected a communications failure. The
sense code is X'080F6051'.
~~~~~~~~~~~~~~~~~~~~


The SNA Formats manual tells me that 080F6051 is:
~~~~~~~~~~~~~~~~~~~~
Access Security Information Invalid: The request specifies an Access
Security Information field that is unacceptable to the receiver; for
security reasons, no further detail on the error is provided. This sense
data is sent in FMH-7 or UNBIND.
~~~~~~~~~~~~~~~~~~~~


On the 515, I am getting this error:
~~~~~~~~~~~~~~~~~~~~
Message ID . . . . . . : CPF1269 Severity . . . . . . . : 00
Message type . . . . . : Information
Date sent . . . . . . : 10/19/07 Time sent . . . . . . : 09:29:07

Message . . . . : Program start request received on communications device
SYSTEM was rejected with reason codes 715, 0.
Cause . . . . . : The program start request was rejected in job
001111/QSYS/QCMN. The device belongs to remote location SYSTEM. If the
device is an advanced program-to-program communications (APPC) device, the
program start request was received on mode QSOCCT with unit-of-work
identifier APPN.SYSTEM-C15E493CFBFB-0001. The first reason code means:
Neither password nor user ID was provided, and no default user profile was
specified in the communications entry. The second reason code means: None.
Recovery . . . : See the job log for more information about the problem.
~~~~~~~~~~~~~~~~~~~~

I am using QSECOFR with the same pwd on both servers, so I have no apparent
security issues. QRMTSIGN was tested with *SAMEPRF and *VERIFY for the same
result.

Any ideas?