Re: Write my own printer driver

Create a *WSCST object for the printer. The WSCST specifies the form feed, 
line feed, postion cursor commands and all that glop. The printer API 
manual gives you the form for the source. Then use the CRTWSCST command to 
compile it. Create an *OUTQ for the printer and specify the MFRTYPMDL as 
*WSCST and specify the name and library of your *WSCST.

Dan





Rich Duzenbury <rduz-midrange@xxxxxxxxxxxxxxxxxxx> 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
01/28/2005 02:29 PM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
ISeries List <midrange-l@xxxxxxxxxxxx>
cc

Subject
Write my own printer driver






Hi midrangers,

I'm in a situation where I would like to support a printer that is
unsupported natively by the iSeries. 

I've got the technical specs for the printer, and I've written RPG code
in the past to drive the printer, but I want this printer to be able to
accept any *SCS spooled file on the system, not just spools especially
written for this printer.

Can I write my own printer driver?

Any particularly good resources for getting started?

Thanks.
--
Regards,
Rich

Current Conditions in Des Moines, IA
Overcast
Temp 30.2F, Windchill 22F
Winds out of the Southeast at 9mph


-- 
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.