× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Jay Maynard <jmaynard=NaA3cy51gWZfq8cQ1yknNg@public.gmane.org> wrote
in 20021004133550.A14859@thebrain.conmicro.cx:">news:20021004133550.A14859@thebrain.conmicro.cx:

> On Fri, Oct 04, 2002 at 10:06:12AM -0700, Kirk Goins wrote:
>> Is the 170 attached to a HUB or a SWITCH ? A lot of HUBS are
>> *half duplex.
>
> This is definitely a switch, specifically a D-Link DSS-16+.
>
>> I had a problem once after and OS upgrade where the 400 wasn't
>> auto detecting correctly and manual settings of other than 10 and
>> half would not work. I finally did a rtvcfgsrc, deleted the line
>> and re-created it. Everything worked fine afterwards.
>
> Might have to try that...
> _______________________________________________


Jay,


Is the switch port configured for full duplex or auto duplex?
If it is set as auto duplex then it will not work properly if connected
to a card configured as full duplex.  You will need to configure both
the switch port and card to a consistent setting - either both AUTO or
both FULL.



--
Mike Buglass




As an Amazon Associate we earn from qualifying purchases.

This thread ...

Follow-Ups:
Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.