Re: Display station connection question/issue?

[Pat Barber <mboceanside@xxxxxxxxxxxxxxxx>]

What has changed since it was last working ???? Physical 
move ??? New wires ??? New terminal ???  

When this happens, usually somebody did somthing to cause it....

Using twisted pair, has somebody changed anything at punch down
block(like a phone repair guy)... Is that line punched down ???

Are you out of address space on that port ????

Did you autoconfig or manual config ???


Mark Allen wrote:
> 
> It's been a long time since I had to deal with this, so if someone can tell
> me what I am doing wrong I would greatly appreciate it.
> 
> Configuration
> 
> DSP01-----Twinax cable-----PRT01--Balun--network
> cable--Balun--DSP02--Balun--network cable--Balun--DSP03
> 
> What happens is that DSP03 gets a signon but DSP02 does not, it stays Vary
> On Pending... All other devices are ok.
>  Any ideas or is this not possible?
> 
> I have double and triple checked addresses, they are ok.  Have swapped
> network cables with ones I know work and same result. Swapped baluns with
> ones I know work, no diff....
> 
> Mark Allen
> Director of MIS
> Fast Friends, Inc.
> (601) 888-4392 ext. 13
> www.fast-friends.com
> 
>   ------------------------------------------------------------------------
>                   Name: winmail.dat
>    winmail.dat    Type: application/ms-tnef
>               Encoding: base64
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---