Ethernet switch question -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

The 10Base adapter on our 400 is plugged into an Ethernet switch. We have had
occasional power glitches or other problems that require us to reset the
switch. When we do this, the only device on the network that even notices is
the AS400. It throws a CPA58EE error and puts the line into recovery
pending.  The only way we've been able to get things going again is to end
TCP, vary off the line, vary on the line, and restart TCP. Fortunately, this
doesn't happen very often, but it's pretty disruptive when it does.
Is there a setting I should change on the line so it's not so sensitive?
Also, we're planning to upgrade to a 100base adapter. Will it act any
differently?
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.