Re: ECS doesen't work

[watern@xxxxxxxxxxxxxx]

Gary, the switch settings on my modem are as per the second example in your
original note:

1up2up3dn4dn5through7up8&9dn10up11dn12through15up16dn

I was not using QESLINE. I'm afraid I cannot remember why I decided not to
use it. It was probably so that i could have one line description for each
location that I planned to dial out to.  I was being helped by an Ops
Supervisor when setting my machine up.

I created a new SDLC line description of my own, with a controller. I seem
to remember having to make sure the STNADR parameter matched on line and
controller, though I picked an arbitrary value of 66 for both.

My line description parameters are :
RSCRCNAME(CMN01) ONLINE(*NO) ROLE(*NEG) CNN(*SWTPP) AUTOCALL(*NO)
MODEM(*NORMAL) SWTCNN(*BOTH) AUTOANS(*YES) AUTOANSTYP(*DTR) AUTODIAL(*YES)
DIALCMD(*V25BIS) THRESHOLD(*OFF) DUPLEX(*FULL) MODULUS(8)

My contoller description parameters are:
 LINKTYPE(*SDLC) ONLINE(*YES) SWITCHED(*YES) INLCNN(*DIAL)
DIALINIT(*LINKTYPE) SWTDSC(*YES) AUTOCRTDEV(*ALL) on the controller
description.

Nigel  Waters




+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---