Re: 7852-400

["John M Ross" <jross@xxxxxxxxxxx>]

I had a problem on a new AS400 with the ECS line. Went from a CISC to a
RISC. The line was not associated with the controller after the conversion.
Once I changed it, it worked fine again.

John Ross
WWW.TS400.COM


-----Original Message-----
From: Chris.Chambers@v2music.com <Chris.Chambers@v2music.com>
To: midrange-l@midrange.com <midrange-l@midrange.com>
Date: Wednesday, April 28, 1999 1:33 PM
Subject: 7852-400


>
>While we are on the subject I am using one with a brand new AS400 4.3 and
>initially trying to connect to ECS using the system supplied QESLINE. I get
>nothing other than a message saying the CTL failed when performing
>SNDPTFORD.
>
>Initially the line was for HRDWRSC 'DC03' which I had to change to CMN01. I
>vary on Line and then controller. I start SBS QCMN. I perform SNDPTFORD -
>line fails. DIP switches are factory supplied. ANZPRB suggests 90% hardware
>failure but modem works at hardware suppliers.
>
>Any ideas?
>
>
>+---
>| This is the Midrange System Mailing List!
>| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
>| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
>| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator:
david@midrange.com
>+---
>



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---