Re: 7852-400

[pytel@xxxxxxxxxx]

Look at history log. Normally, when communication error occurs, system
sends short informational message to QSYSOPR and a couple of more
informative messages to history log. These will contain error code, which
can be traced to exact failure - carrier loss or smth.

Best regards
    Alexey Pytel



Chris.Chambers@v2music.com on 04/28/99 12:39:28 PM

Please respond to MIDRANGE-L@midrange.com

To:   midrange-l@midrange.com
cc:    (bcc: Alexei Pytel/Rochester/IBM)
Subject:  7852-400





While we are on the subject I am using one with a brand new AS400 4.3 and
initially trying to connect to ECS using the system supplied QESLINE. I get
nothing other than a message saying the CTL failed when performing
SNDPTFORD.

Initially the line was for HRDWRSC 'DC03' which I had to change to CMN01. I
vary on Line and then controller. I start SBS QCMN. I perform SNDPTFORD -
line fails. DIP switches are factory supplied. ANZPRB suggests 90% hardware
failure but modem works at hardware suppliers.

Any ideas?


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---