Re: Cannot Prompt CL commands

[batthish@xxxxxxxxxx]

Hi Paul,

I have noticed that you can only prompt CL when the CL source has been
saved to an AS/400.  In other words, prompting local CL files or unsaved CL
files will give the error you mention below.  I have opened an internal
defect for this problem.

thanks,
Violaine Batthish
CODE/400 Project Lead
batthish@ca.ibm.com          IBMCA(BATTHISH)

CODE/400 page:  http://www.ibm.com/software/ad/varpg
WDT/400 Support :
http://www.ibm.com/software/ad/wdt400/update_downloads.html



                                                                                
                               
                    Paul Jackson                                                
                               
                    <pjackson@costco.c       To:     "'CODE400-L@midrange.com'" 
<CODE400-L@midrange.com>       
                    om>                      cc:                                
                               
                    Sent by:                 Subject:     Cannot Prompt CL 
commands                            
                    owner-code400-l@mi                                          
                               
                    drange.com                                                  
                               
                                                                                
                               
                                                                                
                               
                    04/06/2001 01:54                                            
                               
                    PM                                                          
                               
                    Please respond to                                           
                               
                    CODE400-L                                                   
                               
                                                                                
                               
                                                                                
                               



Hello,

is there any particular reason that would cause me to get a dialog box that
says "Unable to access CL host prompting or help." when I press F4 on a CL
command in the code editor screen?
I already have a STRCODE session active when I try this and am not sure
where to turn next.

Thanks in advance for any help

Paul Jackson      *
> iSeries 400 Technical Programming Analyst
> Costco Wholesale, Inc.
> 999 Lake Drive
> Issaquah, WA  98027-8990
> Phone:   425-313-8594
> Fax:        425-313-6800
> Email:    mailto:pjackson@costco.com
>
>
+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---




+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---