Re: IBM Original HTTP Server translating content -- WEB400

Aaron,

I haven't configured the Original server for sometime, but I think there
was a place you had to specify "%%EBCDIC/EBCDIC%%" or something like
that.  Sorry I can't be more help there.

I'v never had any trouble debugging in Apache: it works the same for me
as it did under Classic.  The only trick is finding the correct job.  If
your traffic isn't too bad, you can just end all the jobs accept one. 
When I'm debugging during heavy traffic times, I just watch for the job
that stops and starts the most and 98% of the time I can get in on that
job.

Just to review the process for anyone who may not know:

1.  Find the job under QHTTPSVR subsystem.  There are some pre-start
jobs(terminology?) that you can skip over.  A good place to start is
with the first job whose "function" is listed as QZSRCGI (should be the
fourth one), although this is subject to change over the life of the
server instance.

2.  STRSRVJOB on that job.

3.  STRDBG on the program you want.  Naturally you usually want to
UPDPRD(*YES) and set a break point.  

4.  Initiate the CGI program through the appropriate browser call.

The debugger should open the next time the program runs ON THAT JOB.  If
the web page finishes processing normally then either the break point is
set wrong or that request went to another job in the subsystem.  Again,
this is the tricky part!

Also good to remember is that you only have so long to spend in debug
before the HTTP request times out.  You can keep debugging when this
happens, but you won't get to see any of the HTML output in your browser
if you let the job time out!

When you are done debugging, be sure to ENDDBG and ENDSRVJOB so as not
to disrupt any of your web clients, not that I've ever done such a
thing... :-)

Joel
http://www.rpgnext.com


On Tue, 2003-08-12 at 15:54, Bartell, Aaron L. (TC) wrote:
> Hi,
> 
> I am working with the IBM Original HTTP Server and IBM Apache.  From my RPG
> program I am reading from standard input and writing the result of the read
> to a file in the IFS.  When the program gets called via the IBM Original
> HTTP Server the query string doesn't get translated from the query string
> (for instance, spaces are still %20), but when I run the same program
> through the Apache server it translates the query string for me.
> 
> Is there a parameter I can set in the IBM Original HTTP Server that will
> make the translation happen automatically like the Apache server does?
> 
> Also, the reason that I am using the IBM Original HTTP Server is because I
> can't seem to figure out how to debug my programs with the Apache server,
> and it gives inadequate error messages when something goes wrong.  I can't
> get a service job started on job because the job comes into existence when
> the request comes in and leaves once the request is done.  Is this a setting
> somewhere that I can change to fix this?
> 
> TIA,
> Aaron Bartell 
> _______________________________________________
> This is the Web Enabling the AS400 / iSeries (WEB400) mailing list
> To post a message email: WEB400@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/web400
> or email: WEB400-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/web400.