×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
On 02/10/2008, at 2:15 PM, Scott Klement wrote:
Hello,
Where's your reference for this? I scanned the CLI Reference for
"result set" but did not see such a statement.
Hmmm.. not sure. I thought I read it somewhere, though. Am I wrong?
If I thought that I'd say so. I'm not sure. I know SQL CLI can
process result sets. I thought it could create them (in the specific
sense we're using here rather than the generic "SQL queries create
result sets" interpretation). Because you were so emphatic about CLI
not supporting them I went looking for the specific reference. If
it's documented as not possible then I won't waste time on it but if
it's not then I have some ideas that might allow it--not sure though
never done this in CLI. Have proved other things possible that
supposedly greater minds said were not.
Regards,
Simon Coulter.
--------------------------------------------------------------------
FlyByNight Software OS/400, i5/OS Technical Specialists
http://www.flybynight.com.au/
Phone: +61 2 6657 8251 Mobile: +61 0411 091 400 /"\
Fax: +61 2 6657 8251 \ /
X
ASCII Ribbon campaign against HTML E-Mail / \
--------------------------------------------------------------------
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
