Re: Initialize array in D-Spec

[Jerry Adams <jerry@xxxxxxxxxxxxxxx>]

Well, of course, there's %elem, Bob, but I think you meant anything you 
hadn't heard of. :-)


Has you new box arrived yet?  Or is Santa going to drop it down the chimney?


        * Jerry C. Adams
*iSeries Programmer/Analyst
B&W Wholesale Distributors, Inc.* *
voice
        615.893.8633x152
fax
        615.995.1201
email
        jerry@xxxxxxxxxxxxxxx <mailto:jerry@xxxxxxxxxxxxxxx>



Bob Cozzi wrote:

> Any other built-ins besides %SIZE and %DIV that are allowed on the D spec?
>
> -Bob Cozzi
> www.RPGxTools.com
> RPG xTools - Enjoy programming again.
>
> -----Original Message-----
> From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
> On Behalf Of Barbara Morris
> Sent: Monday, December 12, 2005 12:39 PM
> To: rpg400-l@xxxxxxxxxxxx
> Subject: Re: Initialize array in D-Spec
>
> Bob Cozzi wrote:
>  
>
> > When did IBM start allowing the %DIV to be used on the D specs?
> > This was supposed to be in V3R1 but never got put in as far as I know.
> > This would be wonderful if it works.
> >
> >    
>
> %DIV was introduced in V4R4; it's always been allowed in D specs.  (I
> just checked the V4R4 manual, and D specs are explicitly mentioned for
> %DIV.)
>
>