× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Tony,
If you don't have RPG xTools you have to call CL or the Job Info API. If you
have RPG xTools use the GetJobType() procedure. It returns "I" for
Interactive, and "B" for batch.

-Bob Cozzi
www.RPGxTools.com
RPG xTools - Enjoy programming again.


-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Tony Carolla
Sent: Thursday, September 08, 2005 2:44 PM
To: RPG programming on the AS400 / iSeries; RPGIV@xxxxxxxxxxxxxxx
Subject: Detection of batch/interactive

I am writing an RPG program that I want users to run in batch mode. My 
standard solution to this is to write a CL program that submits the RPG to 
batch, and point a CMD at the CL program. But I had this idea... What if the

RPG could detect whether or not it was running in batch, and if it wasn't 
submit a job to batch, that would call the same program, and terminate the 
interactve one? 

I have the logic mapped out in RPG, but I can't figure out how to detect if 
the program is running in Batch. I don't see anything in the PSDS that shows

this... Can it be done? 


As an Amazon Associate we earn from qualifying purchases.

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.