× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Toney,
The subfield from the API is:  QUSJT02


-Bob Cozzi
www.RPGxTools.com
RPG xTools - Enjoy programming again.


-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Tony Carolla
Sent: Thursday, September 08, 2005 2:44 PM
To: RPG programming on the AS400 / iSeries; RPGIV@xxxxxxxxxxxxxxx
Subject: Detection of batch/interactive

I am writing an RPG program that I want users to run in batch mode. My 
standard solution to this is to write a CL program that submits the RPG to 
batch, and point a CMD at the CL program. But I had this idea... What if the

RPG could detect whether or not it was running in batch, and if it wasn't 
submit a job to batch, that would call the same program, and terminate the 
interactve one? 

I have the logic mapped out in RPG, but I can't figure out how to detect if 
the program is running in Batch. I don't see anything in the PSDS that shows

this... Can it be done? 


As an Amazon Associate we earn from qualifying purchases.

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.