Re: No connection to System from HMC after firmware upgrade

That SRC says: Service Processor took multiple resets and will not boot
any further.

You'll likely need to reset the FSP to the old code and start again. I'll
be interested in what IBM has to say.

--
Jim Oberholtzer
Chief Technical Architect
Agile Technology Architects


On Mon, Jan 23, 2023 at 9:12 AM Pete Helgren <pete@xxxxxxxxxx> wrote:

Thanks all....

So, I was able to get to the location where the system is. Looking at
the SRC on the panel this morning I see B181 7212. I don't see many
recent hits on that SRC. Do you see a downside to attempting an IPL? I
haven't tried because I am worried I'll find out that I *shouldn't* IPL.

Jim, your recommendation to contact software support is a good one.
I'll create a ticket this morning. Open to any other recommendations
while I wait on IBM.

Pete Helgren
www.petesworkshop.com
GIAC Secure Software Programmer-Java
GIAC Cloud Penetration Tester
AWS Certified Cloud Practitioner
Microsoft Certified: Azure Fundamentals

On 1/22/2023 5:33 PM, Rob Berendt wrote:

Also, sometimes the autorefresh doesn't work when talking between the HMC
and the Power system. Click on the URL and press enter to manually

refresh.

On Sun, Jan 22, 2023 at 6:03 PM Rob Berendt<robertowenberendt@xxxxxxxxx>
wrote:

I have seen some of these "No Connections". I think I just had to wait

a

lot longer than I thought I should have to. Been awhile though.

On Sun, Jan 22, 2023 at 4:33 PM Pete Helgren<pete@xxxxxxxxxx> wrote:

"She's dead Jim" is all the comes to mind....

Finally got around to updating the HMC (went well) and then decided to
bite the bullet and upgrade the firmware on my Power 9. All seemed to
be going well until I got to the activating stage where the FSP was
supposed to reboot. It never came back....

Upgraded the firmware from VL910 to VL950. System is a 9009-41A, IBM i
at 7.4 (latest TR and PTF IIRC). The error I see on the system panel

in

the HMC is "Firmware not ready" - No connection 0406-0001-000000. All
things point to the FW upgrade failing somehow. The system is remote

so

I will need to get in front of it to see what SRC's are displaying.

Not

sure how to recover from a firmware upgrade failure at this point. No

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxxxxxxxxxx for any subscription related
questions.