RE: Print device to Windows shared printer

9100 is what I tried. Right now, the print device has a CPD337F message.


Remote device rejected an attempt by the writer to open a connection.

Cause . . . . . : This error may have occurred for the following reasons.
1) An incorrect port number or internet address was specified
in the printer device description.
2) The remote device, if it is a printer, may be busy printing
from another host
3) The remote device, if it is a printer, may not be ready to
print and may require operator intervention.

Recovery . . . : Do one of the following:
1) Verify that the correct port number and internet address was
specified in the printer device description. If a remote location
name was used, verify that the internet address for this location
name is correct. Start the writer if it has ended and try printing
again.
2) No recovery action is required. Printing will continue when
the writer is able to use the printer.
3) Ready the printer. Printing will continue when the printer
becomes ready to print.




-----Original Message-----
From: John McKee [mailto:jmmckee3@xxxxxxxxx]
Sent: Wednesday, January 31, 2018 12:14 PM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Subject: Re: Print device to Windows shared printer

There are a couple of other ports, as I recall. But 9100 is the best option, since part of that is involved with allowing the i to control the printer. Stop doing something for three years and lots of cobwebs start accumulating.

John McKee