×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Trying to figure out that "concurrent remove". Manual says DST required
https://www.ibm.com/support/knowledgecenter/ssw_ibm_i_73/rzarm/rzarmrmvdsk.htm
So I thought I'd step though it a little.
STRSST
3. Work with disk units
2. Work with disk configuration
12. Work with removing units from configuration
Again, the manual starts with:
<snip>
If you are not already using dedicated service tools (DST), perform a
manual initial program load (IPL) to start DST.
</snip>
Which makes me wonder why, if this is true, this is even an option in SST.
https://www.ibm.com/support/knowledgecenter/ssw_ibm_i_73/rzarm/rzarmremdskunit.htm
So, can I really use this in SST?
And, is there any value to running
STRASPBAL TYPE(*ENDALC)
followed by
STRASPBAL TYPE(*MOVDTA)
And, since WRKDSKSTS shows the new units as still at 0.0% used preceeding
that by
STRASPBAL TYPE(*CAPACITY)
Rob Berendt
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.