maybe to see it NetServer is running:

Starting and Ending IBM i NetServer - Any configuration changes made to IBM i NetServer, with the exception of share and session administration, do not take effect until the you stop and then start the server. You must have *IOSYSCFG authority to use the following to end and start IBM i NetServer:

CALL QZLSSTRS PARM('0' X'00000000')

Determining if IBM i NetServer is Running - Use the Work with Active Job (WRKACTJOB) command to verify that there is a QZLSSERVER job running under the QSERVER subsystem. If the QZLSSERVER job is not active, you must start IBM i NetServer.
IBM i NetServer Connections - Using the Work with TCP/IP Network Status (NETSTAT *CNN) command you should see the following entries. If these connections do not exist, restart IBM i NetServer.
* * netbios > 001:27:44 Listen
* * netbios > 000:00:01 *UDP
* * netbios > 000:00:00 *UDP
* * netbios > 000:30:57 Listen
For OS/400 releases that support CIFS (Common Internet File System) protocol over TCP/IP, you will also see the following entry:
* * cifs 001:27:32 Listen
Note: The NETSTAT command output may be many pages in length.


I also recall some netserver "tools" here:

Paul Nelson wrote on 12/30/2015 9:20 AM:
And IBM couldn't help, even though they were being paid.

Paul Nelson
Cell 708-670-6978
Office 409-267-4027

This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].