×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
If you are doing an upgrade from an Image Cat, then your IPL Source (IPLSRC) on the PWRDWNSYS command should be *IMGCLG and then another line will show up and you put the name of the image catalog in.
After you complete the upgrade, make sure you put the special 7.1 PTFs on which are required before loading any additional PTFS. At this point, IPL to B, and load all the rest of your PTFs.
Pete
--
Pete Massiello
iTech Solutions
http://www.itechsol.com
http://www.iInTheCloud.com
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Buddy McClean
Sent: Thursday, December 11, 2014 12:54 PM
To: midrange-l@xxxxxxxxxxxx
Subject: IPL Source
Good Day,
I am upgrading from 6.1 to 7.1. I have watched a Common presentation on the upgrade and the only part that is fuzzy for me is the part around upgrading by doing an IPL from the image catalog, load the system to IPL-A. Then ipl from IPL-A.
Is there anything I need to set or watch for before new system loads from IPL-D to IPL-A, for the subsequent IPL from IPL-A?
Then make sure after the new system is fully loaded, ipl from IPL-B to load the PTF's?
Thanks
Buddy
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a moment to review the archives at
http://archive.midrange.com/midrange-l.
midrange.com
