RE: HMC and ASM

All good questions but I am not physically at the box to check. Will need
to make a trip to confirm. I would not think the ping would have worked,
however, if we had the wrong address, when plugged directly into the AS400
HMC port.

Dave Snyder

From:
"Pete Massiello" <pmassiello-ml@xxxxxxxxxxxx>
To:
"'Midrange Systems Technical Discussion'" <midrange-l@xxxxxxxxxxxx>
Date:
08/24/2009 05:34 PM
Subject:
RE: HMC and ASM
Sent by:
midrange-l-bounces@xxxxxxxxxxxx



Dave,

Do you know if you really have the correct address of the
port?

From the 520 Bezel, you can go into Manual mode, and then go to 30, hit

enter. You will see the addresses for both the HMC1 and HMC2 ports, this
will insure that you are using the right address. Is the PC setup to be
on
the SAME subnet with a Mask of 255.255.255.0? I assume you know that when
you plug a cable into the back, you see the green light flash?

Pete

Pete Massiello
iTech Solutions
http://www.itechsol.com




NOTICE - This e-mail message is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this message, you are hereby notified that any dissemination, distribution or copying of this message is strictly prohibited. If you have received this message in error, please notify the sender by e-mail or telephone and delete the original and all copies of this message immediately.
www.ephratanationalbank.com