Dave,
Do you know if you really have the correct address of the port?
From the 520 Bezel, you can go into Manual mode, and then go to 30, hit
enter. You will see the addresses for both the HMC1 and HMC2 ports, this
will insure that you are using the right address. Is the PC setup to be on
the SAME subnet with a Mask of 255.255.255.0? I assume you know that when
you plug a cable into the back, you see the green light flash?
Pete
Pete Massiello
iTech Solutions
http://www.itechsol.com
Add iTech Solutions on Facebook:
http://www.facebook.com/group.php?gid=126431824120
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Dave Snyder
Sent: Monday, August 24, 2009 2:51 PM
To: Midrange Systems Technical Discussion
Subject: Re: HMC and ASM
I am not physically at the box right now to try the telnet. I will have to
make a trip to give it a shot.
Thanks.
Dave
From:
Lukas Beeler <lukas.beeler@xxxxxxxxxxxxxxxx>
To:
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Date:
08/24/2009 02:46 PM
Subject:
Re: HMC and ASM
Sent by:
midrange-l-bounces@xxxxxxxxxxxx
On Mon, Aug 24, 2009 at 20:23, Dave Snyder<DSnyder@xxxxxxxx> wrote:
If I power it down and remove power, will it reset the IP address of the
port back to the default, or only if I remove the cable from the port,
or
never until a "hard" FSP reset is done like you mention.
The last one. But cycling the power might help if the ASMI is "stuck"
somehow.
Did you do the telnet test?
NOTICE - This e-mail message is intended only for use by the addressee(s)
named herein and may contain legally privileged and/or confidential
information. If you are not the intended recipient of this message, you are
hereby notified that any dissemination, distribution or copying of this
message is strictly prohibited. If you have received this message in error,
please notify the sender by e-mail or telephone and delete the original and
all copies of this message immediately.
www.ephratanationalbank.com
midrange.com
