Re: HMC and ASM

If I power it down and remove power, will it reset the IP address of the
port back to the default, or only if I remove the cable from the port, or
never until a "hard" FSP reset is done like you mention.

Thanks,

Dave Snyder

From:
Lukas Beeler <lukas.beeler@xxxxxxxxxxxxxxxx>
To:
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Date:
08/24/2009 02:19 PM
Subject:
Re: HMC and ASM
Sent by:
midrange-l-bounces@xxxxxxxxxxxx



On Mon, Aug 24, 2009 at 19:56, Dave Snyder<DSnyder@xxxxxxxx> wrote:

I believe we at one point connected our HMC to the default ip address

but

then changed it. We are trying to connect via that same (the changed

one)

ip address and can ping it but not get to the ASM interface via the
browser now, so that we can once again change it, Maybe we need to reset
it - how do we do that without being in ASM.

What browser are you using? Older versions of the FSP firmware have
serious SSL compatibility issues with modern browsers.

Can you telnet to port 443 of the FSP IP address? If yes, then it's
most probably an SSL issue.

If not, try restarting the FSP (shutdown all LPARs, remove power from
the machine, power it up again).

In the worst case, you can reset the FSP to it's default settings -
however there are some important things that should be considered
before doing this. There's a little dip switch on the FSP card witch
after moving to the other position will completely reset the FSP. But
don't do this without reading the appropriate documentation.



NOTICE - This e-mail message is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this message, you are hereby notified that any dissemination, distribution or copying of this message is strictly prohibited. If you have received this message in error, please notify the sender by e-mail or telephone and delete the original and all copies of this message immediately.
www.ephratanationalbank.com