RE: slow response time for first, and only first time program is run.

And by the way, who the @#$% is wading through a list of 10,000 objects? I've never been that bored (or wired) in my life.

Jerry C. Adams
IBM System i Programmer/Analyst
--
B&W Wholesale
office: 615-995-7024
email: jerry@xxxxxxxxxxxxxxx


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Chuck Lewis
Sent: Friday, August 14, 2009 3:01 PM
To: Midrange Systems Technical Discussion
Subject: RE: slow response time for first, and only first time program is run.

What's the reason for manipulating this outq ?

Two things that could speed it up:

1) Get the stuff out of PRT01 and to an outq(s) that are specific to
what it is (i.e. GL, AP, etc).
2) Whatever your are looking for in PRT01 - have it go to an outq you
create for it

HTH,

Chuck

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Booth Martin
Sent: Friday, August 14, 2009 3:23 PM
To: Midrange Systems Technical Discussion
Subject: Re: slow response time for first, and only first time program
is run.

Narrowed down further. Here is the command:

WRKOUTQ OUTQ(QUSRSYS/PRT01) OUTPUT(*PRINT)

10,000 spoolfiles are in this queue.

Run from the command line = 2+ minutes.
Run again immediately, = 3 seconds
Run again 5 minutes later = 3 seconds