What's the reason for manipulating this outq ?

Two things that could speed it up:

1) Get the stuff out of PRT01 and to an outq(s) that are specific to
what it is (i.e. GL, AP, etc).
2) Whatever your are looking for in PRT01 - have it go to an outq you
create for it

HTH,

Chuck

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Booth Martin
Sent: Friday, August 14, 2009 3:23 PM
To: Midrange Systems Technical Discussion
Subject: Re: slow response time for first, and only first time program
is run.

Narrowed down further. Here is the command:

WRKOUTQ OUTQ(QUSRSYS/PRT01) OUTPUT(*PRINT)

10,000 spoolfiles are in this queue.

Run from the command line = 2+ minutes.
Run again immediately, = 3 seconds
Run again 5 minutes later = 3 seconds


This thread ...

Follow-Ups:
Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].