Re: BRMS CPF5140 Error

[Loyd Goodbar <loyd@xxxxxxxxxxxxxx>]

Advantages:
* No need to have the console signed on for BRMS to take it over.
* Once configured it's "fire and forget".
* If for whatever reason an error occurred (no tape loaded), I think the
worst condition is the system stays in restricted state until the time limit
is reached and controlling subsystem is started.

Disadvantages:
* Console is NOT available during the backup. No way to monitor the system
at all, TCP/IP is down too.
* Cannot monitor status during backup. Must review DSPLOGBRM and job log for
problem determination.
* If it goes kaput, must go into DST and force end the batch restricted
state.

Despite the scary-sounding disadvantages, I still prefer the batch
restricted state backup, if only because I don't need CONSOLE signed on just
to "manage" an interactive backup.

--Loyd


On Thu, Jun 4, 2009 at 3:54 PM, Jeff Crosby <jlcrosby@xxxxxxxxxxxxxxxx>wrote:

> If the console is not available, then what's the advantage of the backup
> being in batch?  Strictly the time limit?  Or is the time limit available
> with *CONSOLE also?
>
> Reason I ask is the once (and only once) the operator did not ready a tape
> in the MLB device.  At 12:01am the backup fired off, couldn't find anywhere
> to backup to, and sat there until I came in at 7am.
>
> It's only happened once, but my next step would have been to a check in the
> *EXIT point at the start.  If no tape was available, I assume there would
> be
> a way I could abort the whole thing, email me, I call the operator, wake
> her
> up, make her go into the office (she has a key) and put in the $#@&%*$
> tape.
> <g>
>
> --
> Jeff Crosby