RE: 3581 tape unit firmware

We have 24/7 on the tape unit but isn't the customer responsible for the firmware?

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of Bentley Pearson
Sent: Tuesday, August 07, 2007 10:25 AM
To: Midrange Systems Technical Discussion
Subject: RE: 3581 tape unit firmware


I remember this being done, but the IBM engineer did it for me. He was
replacing (and I not kidding here) a rubber band in the drive. IIRC, he
pulled the update down and applied it from the iSeries. I do not think a
pc was ever involved. Do you have hw support? If so, have you considered
calling IBM?

Bentley Pearson
Vice President - Information Services
Southland National Insurance Corporation
1812 University Blvd
Tuscaloosa, Al
35403
205 345 7410
bpearson@xxxxxxxxxxxxxxxxxxxxx


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of carl j novit
Sent: Tuesday, August 07, 2007 9:27 AM
To: Midrange Systems Technical Discussion
Subject: Re: 3581 tape unit firmware

I've only done it from a PC with a serial cable.

Carl Novit
Vice President
FRS, Inc.
843.720.7436 ext. 7708
Carln@xxxxxxxxx



"Burns, Bryan" <Bryan_Burns@xxxxxxxxxxxx>
Sent by: midrange-l-bounces@xxxxxxxxxxxx
08/07/2007 10:08 AM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
<MIDRANGE-L@xxxxxxxxxxxx>
cc

Subject
3581 tape unit firmware






Good morning folks,
Have any of you updated firmware on a 3581 tape drive or autoloader? I
need to do this and need some direction because I don't quite understand

the different methods outlined in the Service Guide. Can it be done
from
our system i 520?
Thanks in advance.
Bryan Burns
IBM Certified Specialist - iSeries System Command Operations V5R2
M.I.S. Department
ECHO, Incorporated
www.echo-usa.com