RE: Changed our IP address now SMTP is broken

Yes and Yes, but thanks for the suggestion



-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Wilt,
Charles
Sent: Thursday, August 02, 2007 9:27 AM
To: Midrange Systems Technical Discussion
Subject: RE: Changed our IP address now SMTP is broken

Allen,

SMTP expects to be able to do a (reverse?) lookup for the
boxes IP address.

When you changed you IP address, did you change the iSeries
hosts table?

What about DNS servers?

HTH,
Charles

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of

Allen

Sent: Thursday, August 02, 2007 9:13 AM
To: MIDRANGE-L@xxxxxxxxxxxx
Subject: Changed our IP address now SMTP is broken

While setting up VPN on our network we had to change the

IP

address of our AS400 (V5R1) from 192.168.1.50 to

192.168.2.50

Everything appears to be back up and working (Users can

log

on, map drives etc) except for SMTP

SMTP will start up (jobs QTSMTPBRCL QTSMTPBRSR QTSMTPCLTD
QTSMTPSRVD) they stay running for about 5 minutes



Then they end with the following in the joblog:

TCP206E Diagnostic 40 08/02/07

08:39:56

QTMSCLCD QTCP *STMT QTMSCLCD QTCP

From module . . . . .

.

. . : QTMSCLUT

From procedure . . .

.

. . : PostTCP206E__FiPc

Statement . . . . . .

.

. . : 625

To module . . . . . .

.

. . : QTMSCLCD

To procedure . . . .

.

. . : main

Statement . . . . . .

.

. . : 275

Message . . . . :
SMTP received an error from a sockets function.

Cause . . . . . :
Probable causes are: -- network problem -- remote host

problem Technical
description . . . . . . . . : SMTP received errno 3421

from sockets

function

BIND(). To see the meaning of the errno, enter command

DSPMSGD
RANGE(CPEXXXX), where XXXX is the four digit errno value.




TCP2081 Diagnostic 20 08/02/07

08:39:56

QTMSUTL QTCP *STMT QTMSCLCD QTCP
*STMT

From module . . . .

.

. . . : QTMSUTIL


From procedure . .

.

. . . : qtms_IssueMessage


Statement . . . . .

.

. . . : 1747


To module . . . . .

.

. . . : QTMSCLCD


To procedure . . .

.

. . . : main


Statement . . . . .

.

. . . : 276


Message . . . . :
SMTP unable to bind to Internet Protocol interface


192.168.1.50.


Recovery . . . :
Check the status of Internet Protocol interface


192.168.1.50 with

the

command NETSTAT *IFC, and start if necessary, or


correct problems.




When I run the command NETSTAT *IFC is shows our new IP
address 192.168.2.50 not the 192.168.1.50 that is shown in

the message above from the joblog

So something somewhere still has our old IP address



Any ideas would be greatly appreciated



John











--
This is the Midrange Systems Technical Discussion
(MIDRANGE-L) mailing list To post a message email:
MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe, or

change

list options,
visit:

http://lists.midrange.com/mailman/listinfo/midrange-l

or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting,
please take a moment to review the archives at
http://archive.midrange.com/midrange-l.

This e-mail transmission contains information that is
intended to be confidential and privileged. If you receive
this e-mail and you are not a named addressee you are hereby
notified that you are not authorized to read, print, retain,
copy or disseminate this communication without the consent
of the sender and that doing so is prohibited and may be
unlawful. Please reply to the message immediately by
informing the sender that the message was misdirected.
After replying, please delete and otherwise erase it and any
attachments from your computer system. Your assistance in
correcting this error is appreciated.