RE: sending email to exchange server

Thanks is how our Exchange admin set up relaying, only allow from the
iSeries 10.* addresses. If you have more than one just be sure they
enter them all. 

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jim Franz
Sent: Tuesday, February 20, 2007 11:41 AM
To: Midrange Systems Technical Discussion
Subject: Re: sending email to exchange server

If they are, then they
need to allow relaying.  If not, then to Exchange, it's just like all
other e-mail from the outside world.  I would have them check the SMTP
service on their Exchange server to make sure that they don't limit

what

IPs are allowed to connect."

We will be sending both inside & outside addresses
some mail to customers
some mail to admin & manager - alerts & status
They are a little leary of open unrestricted relay - they were
blacklisted
for allowing a spammer to take over for a while.
I'm hoping Exchange can restrict relay to only from our iSeries "10." 
private address
jim
----- Original Message ----- 
From: "Mike Cunningham" <mcunning@xxxxxxx>
To: "Midrange Systems Technical Discussion" <midrange-l@xxxxxxxxxxxx>
Sent: Tuesday, February 20, 2007 11:25 AM
Subject: RE: sending email to exchange server

From our Exchange admin.... "We do allow all of the iSeries IP

addresses

to relay through the Exchange server, but from reading the e-mail I'm
not sure if they are trying to send mail through the Exchange server
addressed to external e-mail accounts or not.  If they are, then they
need to allow relaying.  If not, then to Exchange, it's just like all
other e-mail from the outside world.  I would have them check the SMTP
service on their Exchange server to make sure that they don't limit

what

IPs are allowed to connect."

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jim Franz
Sent: Tuesday, February 20, 2007 9:34 AM
To: MIDRANGE-L@xxxxxxxxxxxx
Subject: sending email to exchange server

What can I tell the admin of an Exchange Server so that
email sent from iSeries (via Aaron's RPGMAIL) will be accepted?
iseries pgm has no errors & appears sent ok.
Can telnet to the server from iSeries, port 25 & looks ok.
I am assuming he needs to allow the relay from the iSeries,
but so far he is not "getting it".
jim franz
-- 
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.


-- 
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing

list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.