|
Hi Rhettyou don't say whether this interface has worked before and has only just started playing up or whether it is a new configuration. You also don't indicate what else you have done (as suggested elsewhere).
At the very least you will want to: - check messages on QSYSOPR - check for messages in the job log (WRKJOB) - Check the configuration status of the associated lineIf necessary end the interface, vary the line off and then on again then start the interface again.
Having said all that, I most often see this when the communications parameters on the ethernet line don't match those on the switch.
Check the line description, particularly the LINESPEED and DUPLEX options and make sure they match the configuration on your switch.
Regards Evan Harris At 07:42 p.m. 28/03/2006, you wrote:
The as400's TCP/IP is stuck with message "Starting...". I am stumped. I've checked the swtich, cable, and whatnot. Where should I investigate? Thanks,
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
