RE: TCP/IP Stating...

No joblogs or problems reporting?  Did you check messages in QSYSOPR?
WRKPRB, look in all the output queues for any job logs that might indicate
the error?

Open an iSeries Navigator session and take a look at all the TCP/IP
Interfaces and see what their status is.  Maybe it's only one service, like
FTP or something, that's not completing the start up. 

This sounds familiar to me but so far I cannot recall what this is. It'll
come to me eventually.

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Rhett Hermer
Sent: Tuesday, March 28, 2006 1:53 AM
To: 'Midrange Systems Technical Discussion'
Subject: RE: TCP/IP Stating...

Via command line: STRTCP. (with defaults, *YES to parms) 

I see:

                                                    
      Internet         Subnet           Interface   
 Opt  Address          Mask             Status      
                                                    
      127.0.0.1        255.0.0.0        Active      
      192.168.2.9      255.255.255.0    Starting      

-----Original Message-----
From: midrange-l-bounces+rhetth=info-logic.co.za@xxxxxxxxxxxx
[mailto:midrange-l-bounces+rhetth=info-logic.co.za@xxxxxxxxxxxx] On Behalf
Of Luke Dalton
Sent: 28 March 2006 09:48
To: 'Midrange Systems Technical Discussion'
Subject: RE: TCP/IP Stating...


You're trying to start it, how?  iSeries Navigator or from a command line?  
Please provide more details about what you are doing and what you are seeing
where.

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Rhett Hermer
Sent: Tuesday, March 28, 2006 1:42 AM
To: 'Midrange Systems Technical Discussion'
Subject: TCP/IP Stating...

The as400's TCP/IP is stuck with message "Starting...".

I am stumped. I've checked the swtich, cable, and whatnot. 

Where should I investigate? 

Thanks,