|
On 17/02/2006, at 5:00 AM, rob@xxxxxxxxx wrote:
Joblog has CPD0031-Command SNDPGMMSG not allowed in this setting. So, what am I looking for here?
This message is sent when the command is defined with ALLOW omitting the values *EXEC, *INTERACT or *BATCH. You cannot specify ALLOW(*EXEC | *INTERACT | *BATCH) on commands that have return values defined. SNDPGMMSG has the MSGKEY value defined as a return value thus it will not run via QCMDEXC (or variations such as SYSCMD, system(), etc.).
You'll have to use a CL program (with optional command front-end) to invoke SNDPGMMSG for you or you could try calling the QMHSNDPM API but that's a bit messy to type on a command line.
Regards, Simon Coulter. -------------------------------------------------------------------- FlyByNight Software AS/400 Technical Specialists http://www.flybynight.com.au/ Phone: +61 3 9419 0175 Mobile: +61 0411 091 400 /"\ Fax: +61 3 9419 0175 \ / X ASCII Ribbon campaign against HTML E-Mail / \ --------------------------------------------------------------------
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
