Virtual Ethernet

["don yattaw" <neal_dy@xxxxxxxxxxx>]

   I have virtual ethernet connecting two lpars.  I have configured ip to
   work over the connection and as far as that goes everything is working
   fine.  I would like to get sna over ip to work also, but can't seem to get
   the controllers talking.  Does anyone have any experience with this?  Is
   there any reason it shouldn't work? 

   When I configure the appc controller and attempt to vary it on, i get a
   message cap5714 stating:
   -- Controller xxxxxx runs over a protocol other than TCP/IP, and each of 
     the line descriptions found in the switched line list (SWTLINLST)       
     specifies a hardware resource (RSRCNAME parmeter) that only supports    
    
   TCP/IP.                                                                      
                                               

    

   Thanks,

    

   Don Y

     ----------------------------------------------------------------------

   Mother*s Day is May 9. Make it special with great ideas from the Mother*s
   Day Guide!