Re: Virtual Ethernet -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.




As was mentioned earlier use anynet.  IBM has some good instructions here:
http://www-912.ibm.com/s_dir/slkbase.nsf/1ac66549a21402188625680b0002037e/c0e073485d35f074862569da0063626f?OpenDocument&Highlight=0,anynet




----------------------------
Bryan Dietz
Aktion Associates


midrange-l-bounces@xxxxxxxxxxxx wrote on 05/07/2004 06:19:36 PM:

>    I have virtual ethernet connecting two lpars.  I have configured ip to
>    work over the connection and as far as that goes everything is working
>    fine.  I would like to get sna over ip to work also, but can't seem to
get
>    the controllers talking.  Does anyone have any experience with this?
Is
>    there any reason it shouldn't work?
>
>    When I configure the appc controller and attempt to vary it on, i get
a
>    message cap5714 stating:
>    -- Controller xxxxxx runs over a protocol other than TCP/IP, and each
of
>      the line descriptions found in the switched line list (SWTLINLST)

>      specifies a hardware resource (RSRCNAME parmeter) that only supports

>    TCP/IP.


>    Don Y

This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.