RE: SAVRSTLIB - how to set up the network over ethernet

Can you STRPASTHR (both directions) between the two boxes?

Regards,

Scott Ingvaldson
AS/400 System Administrator
GuideOne Insurance Group

-----Original Message-----
date: Tue, 3 Feb 2004 12:02:07 -0500
from: "Robert Dobrowolski" <r.dobrowolski@xxxxxxxxxxxxxxxxx>
subject: RE: SAVRSTLIB - how to set up the network over ethernet

Greetings,

I am trying to SAVRSTxxx from a new iSeries to our production iSeries.  I
have followed the directions below, but I am still having problems.  I can
SAVRSTxxx from production to new iSeries, but not from new iSeries to
production.  I get a Session start request failed.  Something about not
allowing communications between LUs on the same control point.  What am I
doing wrong?

Thanks,
Bob Dobrowolski
Programmer/Analyst
Star Stainless Screw Co.
(973) 256-2300  x224
r.dobrowolski@xxxxxxxxxxxxxxxxx
USS Cole - Never Forgotten 12 OCT 2000
   
This message and accompanying documents are covered by the Electronic
Communications Privacy Act, 18 U.S.C. §§ 2510-2521, and contains information
intended for the specified individual(s) only. This information is
confidential. If you are not the intended recipient or an agent responsible
for delivering it to the intended recipient, you are hereby notified that
you have received this document in error and that any review, dissemination,
copying, or the taking of any action based on the contents of this
information is strictly prohibited. If you have received this communication
in error, please notify us immediately by e-mail, and delete the original
message.