RE: Differences among network printer setups

["Jones, John (US)" <John.Jones@xxxxxxxxxxxxxxxxxxxxxxx>]

Why not change the WRKWTR command instead: CHGCMDDFT CMD(QSYS/WRKWTR)
NEWDFT('WTR(*ALL)')

Do that now and make a note to do it again after every OS upgrade.

-----Original Message-----
From: Alan Kincer [mailto:w2kprofessional@xxxxxxxxx] 
Sent: Thursday, July 24, 2003 8:49 AM
To: midrange-l@xxxxxxxxxxxx
Subject: Re: Differences among network printer setups


Okay. I think I'm starting to see where this is going.

We usually just type WRKWTR which creates the impression that EVERYTHING
is displayed since no selection criteria is stated.

However adding *ALL has unmasked the "outq only" devices!

It appears the difference lies in that printers normally visible are
type PRT whereas others are RMT.

Do you think there will be any problems if I change the device type to
PRT?


Alan
This email is for the use of the intended recipient(s) only.  If you have 
received this email in error, please notify the sender immediately and then 
delete it.  If you are not the intended recipient, you must not keep, use, 
disclose, copy or distribute this email without the author's prior permission.  
We have taken precautions to minimize the risk of transmitting software 
viruses, but we advise you to carry out your own virus checks on any attachment 
to this message.  We cannot accept liability for any loss or damage caused by 
software viruses.  The information contained in this communication may be 
confidential and may be subject to the attorney-client privilege.