Re: A Green Screen Question -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Hi Bonnie -

I need remove another workstation.  It has one cable in - none out.
I assumed this was the end of the line.

When I remove it, another workstation goes down - blinking light in upper
right.
Both are Info Window II's - configured as 3487s.

Besides removing one of the twin-ax cables from the second workstation,
is there an 'end of line' that needs to be done in workstation setup?

In addition to the things already mentioned, unterminated twinax can act as an antenna and feed electrical system noise on to the cable causing problems. When removing the last workstation, be sure to disconnect the cable from the next-to-last workstation BEFORE disconnecting it from the last workstation.

Make sure, of course, that you disconnect the outgoing cable not the incoming.

If there is a termination switch on the next-to-last workstation, be sure to set it to terminate before disconnecting the cable.

Ken
http://www.ke9nr.net/
Opinions expressed are my own and do not necessarily represent the views of my employer or anyone in their right mind.

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.