Re: A Green Screen Question

["Rick Klopfer" <rixone@xxxxxxxxxx>]

You must be removing the "terminating" workstation and need to change the
one left to the same status.

Check the archives (Midrange.com) and search.  I believe there is something
there about this process.

HTH
Rick--
----- Original Message -----
From: <Bonnie_Lokenvitz@epcmolding.com>
To: <midrange-l@midrange.com>
Sent: Wednesday, February 05, 2003 2:03 PM
Subject: A Green Screen Question


>
>
> I need remove another workstation.  It has one cable in - none out.
> I assumed this was the end of the line.
>
> When I remove it, another workstation goes down - blinking light in upper
> right.
> Both are Info Window II's - configured as 3487s.
>
> Besides removing one of the twin-ax cables from the second workstation,
> is there an 'end of line' that needs to be done in workstation setup?
>
> And if so, how do I do that?
>
> Thanks again,
> Bonnie Lokenvitz
> Engineered Polymers
>
>
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
> To post a message email: MIDRANGE-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>
>