Re: UPS for 9406-170

[Philipp Rusch <Philipp.Rusch@xxxxxxxxxxxx>]

Along with every APC SmartUPS comes a plug to make your own cable(s)
that are accepted by the receptables at the back of the UPS.
You simply cut off and replace the wall plug on your cable with this new one,
be careful about orientaton of the wires (ground is yellow/green and goes to the
middle connector) the plug has screws, no soldering required.

Regards from Germany, Philipp Rusch

Dennis Lovelady schrieb:

> Along these same lines, we have a 9406-170 that was attached to a UPS, but
> the UPS (not under maintenance) has died.  We'd like to opt for a cheaper
> solution (such as SmartUPS).  The problem we have is that the power cables
> do not have ends that will plug into a standard (US) receptacle.
>
> How would I go about obtaining the necessary power cables to eliminate the
> 170's dependence on that defunct piece of equipment?
>
> Thanks,
> Dennis
>
> "Steve Landess" <steve_landess@hotmail.com>@midrange.com on 11/22/2002
> 03:53:44 PM
>
> Please respond to midrange-l@midrange.com
>
> Sent by:    midrange-l-admin@midrange.com
>
> To:    <midrange-l@midrange.com>
> cc:
> Subject:    UPS for 9406-170
>
> This is a multi-part message in MIME format.
> --
> [ Picked text/plain from multipart/alternative ]
> All,
>
> I need to get a UPS for my 9406-170.  My requirements are basically that I
> need to protect my system from power spikes.  I don't need to keep the
> system alive for very long, really just long enough to power it down in the
> event of an extended power outage.  I have done a little research, and I'm
> not sure if I want to use a 9910.
>
> Whatever unit I buy, it would be nice to be able to cable it to the AS/400
> so I can enable the auto power-down feature on the AS/400 side.  Do I have
> to have a particular type of UPS and cable in order to enable this feature?
>
> Anybody have a recommendation for this?  Brand? / Supplier?  Can I just go
> to Fry's Electronics and buy an appropriately sized unit?
>
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
> or email: MIDRANGE-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.