Re: CODE/400 and STRCODE problems

["Peter Dow" <pcdow@xxxxxxxxx>]

Hi Booth, Jon,

Thanks for the help. I've been using the IP address of my PC. I was starting
the editor then doing the STRCODE. And as you mentioned Booth, I have tried
it with some downloaded programs I've accummulated over the years (used to
use the DOS version of Flexedit).

Today I tried starting the CODE daemon then doing the STRCODE with the same
result. I do have a current library Jon, but I haven't seen any place in the
editor to define servers. The popup menu for the CODE daemon has a define
servers option, and that's empty. There must be some place though, because
when I do a File|Open from the editor, two of the several AS/400's I have
defined in Client Access show up, as SYSA and SYSA/ADM, and SYSB & SYSB/ADM.
None of the others show up.

I'll check out the CODE/400 newsgroup and the CODE support on the web too.

Thanks for your help!

Peter Dow
Dow Software Services, Inc.
909 425-0194 voice
909 425-0196 fax

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



__________________________________________________
Do You Yahoo!?
Talk to your friends online with Yahoo! Messenger.
http://im.yahoo.com

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---