|
Change the RUNQRY command so that it can only run in batch.
Mark Allen
MIS Manager
Mattel-Murray
allenma1@mattel.com
-----Original Message-----
From: Bob Clarke 3rd x4502 [mailto:clarke@teri.org]
Sent: Wednesday, August 11, 1999 2:16 PM
To: midrange-l@midrange.com
Subject: Interactive Queries - again!
Hello All. I've been off of the list for a while and recently re-subscribed now that I've once again had additional AS/400 responsibilities thrown at me - but it's nice to be back.
Recently an old ongoing problem has reared it's ugly head and caused me fits - that of rogue users running queries interactively during normal business hours. This of course results in numerous complaints about response time, etc. As I recall from way back then, there really wasn't a whole lot one could do to stop or restrict these miscreants. However quite some time has passed (since I've been involved or concerned about the issue anyway), and I wondered if there has been any new light shed on the matter. Also, we've since upgraded from V3r1 to V3r2 - any changes there that might help?
I hope I'm not beating a dead horse here - my apologies if that's the case. Either way, I'd appreciate any feedback (short of anything resulting in insult or injury, that is). Thanks in advance!
Regards,
Bob Clarke
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
