RE: Table saw shake

["York, Albert" <albert.york@xxxxxxxxxxxxxx>]

You should have tried the command ENDSAWSHK REPLACE(*BELT *BLADE)
REINSTALL(*MOTOR). 

> ----------
> From:         Bill Paris[SMTP:bparis@sccmail.com]
> Sent:         Monday, July 26, 1999 1:16 PM
> To:   MIDRANGE-L@midrange.com
> Subject:      RE: Table saw shake
> 
> This made sense up until the machined pulleys and the link belt...
> *grin*
> 
> Bill Paris
> Sorrento Cheese Co., Inc.
> 716-823-6262 x376
> 
> I forgot to mention, in all my excitement this morning, the table
> saw vibration went away with a belt change and reinstalling motor
> on saw(per installation instructions)... My old belt looked fine,
> but apparently developed a "set" from lack of use in all of the recent
> heat wave(which keeps me away from saw). I also did minor tune up of
> fence and guard/splitter.. I also went out and purchased a new
> Freud LU87 24 tooth thin kerf rip blade, which made a WORLD of
> difference
> in ripping that nasty old pressure treated 2x10's etc,etc.... I
> thought all the hoopla about thin kerfs was just that , HOOPLA, but
> no indeed, they do make a huge difference...
> 
> I also ordered a set of machined pullys and a link belt, which ought to
> help out quite a bit <>>><>><><><>
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
> MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
> david@midrange.com
> +---
> 
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---