Re: [LINUX5250] Unsubscribe

[Scott Klement <klemscot@xxxxxxxxxxxx>]

Heh... you could write tax forms :)


On Mon, 15 Apr 2002, Dennis Lovelady wrote:
>
> If these options don't work for you, you'll need the kit, so read on.  Ask
> your Internet Provider to mail you an Unsubscribing Kit, then follow these
> directions.
>
> The kit will most likely be the standard no-fault type. Depending on
> requirements, System A and/or System B can be used. When operating System
> A, depress lever and a plastic dalkron unsubscriber will be dispensed
> through the slot immediately underneath. When you have fastened the
> adhesive lip, attach connection marked by the large "X" outlet hose. Twist
> the silver- coloured ring one inch below the connection point until you
> feel it lock.  The kit is now ready for use.
>
> The Cin-Eliminator is activated by the small switch on the lip. When
> securing, twist the ring back to its initial condition, so that the two
> orange lines meet. Disconnect. Place the dalkron unsubscriber in the vacuum
> receptacle to the rear.  Activate by pressing the blue button. The controls
> for System B are located on the opposite side. The red release switch
> places the Cin-Eliminator into position; it can be adjusted manually up or
> down by pressing the blue manual release button. The opening is
> self-adjusting. To secure after use, press the green button, which
> simultaneously activates the evaporator and returns the Cin-Eliminator to
> its storage position.
>
> You may log off if the green exit light is on over the evaporator.
> However, if the red light is illuminated, one of the Cin-Eliminator
> requirements has not been properly implemented. Press the "List Guy" call
> button to the right of the evaporator. He will secure all facilities from
> his control panel.
>
> To use Auto-Unsub, first undress and place all your clothes in the clothes
> rack. Put on the velcro slippers located in the cabinet immediately below.
> Enter the shower, taking the entire kit with you. On the control panel to
> your upper right upon entering, you will see a "Shower seal" button. Press
> to activate. A green light will then be illuminated immediately below. On
> the intensity knob, select the desired setting. Now depress the Auto-Unsub
> activation lever. Bathe normally.
>
> The Auto-Unsub will automatically go off after three minutes unless you
> activate the "Manual off" override switch by flipping it up. When you are
> ready to leave, press the blue "Shower seal" release button. The door will
> open and you may leave. Please remove the velcro slippers and place them in
> their container.
>
> If you have problems with the above, or if you prefer the ultrasonic
> log-off mode, press the indicated blue button.  When the twin panels open,
> pull forward by rings A & B. The knob to the left, just below the blue
> light, has three settings, low, medium or high.  For normal use, the medium
> setting is suggested.
>
> After these settings have been made, you can activate the device by
> switching to the "ON" position the clearly marked red switch. If during the
> unsubscribing operation, you wish to change the settings, place the "manual
> off" override switch in the "OFF" position. You may now make the change and
> repeat the cycle. When the green exit light goes on, you may log off and
> have lunch. Please close the door behind you.
>