RE: loading code400 on PC

["Don Freeman" <DFreeman@xxxxxxxxxxxxxxx>]

I could not get CODE to run on my PC either until after I installed Service 
Pack #5. I can't remember what error I was getting, may have been the same as 
yours maybe different. But I would recommend that you install SP5 and see if 
that makes a difference.  Now as to finding the SP5 download page: good luck!  
IBM couldn't have done a better job at obscuring its location even if they had 
intentionally done so.

Just remembered I book marked the full download page because I had to go 
through so many hoops and dead ends to find it:

http://www-1.ibm.com/support/docview.wss?rs=0&org=SW&doc=4001177

(If the news lists breaks up the URL you will have to paste it back together).

Good luck on getting CODE to work but it's definitely worth the installation 
woes. I have configured PDM to send my source to CODE instead of SEU when I use 
the edit and browse options, and intend to have it call IDEBUG instead of the 
AS/400 debugger as well.  I really don't think the learning curve is bad at all 
(the default profile mimics the SEU keystrokes which help in adoption, but can 
be changed to your preferences once you feel comfortable with doing that.



> -----Original Message-----
> From: lee tregerman [mailto:ltregerman@edwardsgarment.com]
>
> I have loaded and removed and reloaded websphere on to my PC without
> success. My computer is a Dell with a 500mHZ Celeron
> processor, 256MB RAM,
> 10giba hard drive and I'm trying to load Websphere
> version5.1. After each
> attempt at using Code400, which is my primary goal, I receive
> the following
> errors: EVFCSVRD illegal operation a-cppwob3i.dll (this comes
> up twice)
> b-kernel.dll. If someone can instruct me how to overcome
> these errors and
>